PigeonChaser™ Repeller - Advanced Ultrasonic & Flash Pigeon Deterrent

PigeonChaser combines two scientifically grounded mechanisms. First, LED flashes: pigeons have a much higher flicker perception than humans, meaning what appears as a steady light to you is experienced as a strobe effect, creating visual discomfort. Second, high-frequency sound waves provide an additional acoustic layer.

For more details and references, see our page dedicated to scientific studies.

Effectiveness may vary depending on environment, installation and level of infestation. Continuous use is recommended for best results.

Our devices are specifically designed to emit ultrasonic frequencies within the hearing range of the targeted pests. While these sounds are generally inaudible to adults, some individuals—especially younger people or those with sensitive hearing—may perceive a brief high-pitched sound when the device is activated.

That said, the device only activates after a short detection delay via its infrared sensor, and the emission lasts only a few seconds. If you’re indoors or not directly facing the device, you’re unlikely to notice anything. Even outdoors, most people report little to no disturbance unless they are standing directly in front of it when it activates. Overall, it’s designed to minimize human discomfort while remaining highly effective against animals.

Due to its power and the use of flashing lights, it may temporarily disturb other animals within its range (such as small mammals or other birds). It should be noted that it merely drives them away from the area due to the discomfort caused—without causing any actual harm.

Although it is very rare, if you have a problem with any of our products, simply contact our customer service via our contact page . We promise to respond to you within 24 hours. All of our repellents are also covered by a 30-day money-back guarantee.

Thanks to a high-capacity battery and a solar panel, the device operates in total autonomy, day and night. You can also use the USB cable to recharge using electrical power.

Set the left dial (sensitivity) to the middle position to begin. Adjust later if needed depending on the desired coverage area. Then select the mode using the right dial:

• Mode 3: ultrasound only
• Mode 4: LED flashes only
• Mode 5 (recommended): variable frequency + flashes

Install the device as needed: stake it into the ground, mount it on a wall, or place it on a stable surface.

If installed in shaded areas, recharge occasionally using the USB cable. In full sunlight, the solar panel provides full autonomy.

Keep the device active at all times, including overnight. LED flashes are particularly effective in low-light conditions.

The built-in PIR motion sensor detects movement within approximately 20–25 feet at a 90° angle and automatically activates the device.

We commit to dispatch orders within 1 to 3 working days. Delivery may take between 3 and 8 working days, depending on your location.

For questions regarding payment or shipping, we invite you to consult our FAQ . For any other request, do not hesitate to contact us via our dedicated page, and you will receive a response within 24 hours.